Calgary Jeep Association
4x4 Related Groups => Tech Talk => Topic started by: slanktapper on September 20, 2017, 09:36:32 PM
-
So my lift is just a 2" on my tj. The instructions didn't say to disconnect the track bar(?) but in order to get the coil out I needed to.
Anywho now I can't seem to line up the track bar with the hole it needs to go in.
I've let the passenger side down as low as I can (disconnected the shock and sway bar was already off) and jacked up the other side and it's still not enough.
Jacked up: https://i.imgur.com/O84p3cs.jpg
(https://i.imgur.com/O84p3csm.jpg)
Level: https://i.imgur.com/RMnpz0L.jpg
(https://i.imgur.com/RMnpz0Lm.jpg)
Any ideas
-
Try a big ratchet strap to the frame and axle to suck it into place.
-
Try a big ratchet strap to the frame and axle to suck it into place.
Ah that would be way easier than that come-along I couldn't figure out how to attach.
I'll try this first thanks!
-
Try a big ratchet strap to the frame and axle to suck it into place.
Yep that did it. Took two straps but I was able to MacGyver it in the correct way. And the wheels appear to be properly spaced too.
Thanks
-
For future jobs where you have to take the track bar off, I always put a tie strap on tight before I take it apart.
-
For future jobs where you have to take the track bar off, I always put a tie strap on tight before I take it apart.
Good call. thanks again!
-
To realign mine I just steer the jeep a tiny bit, the body will move and axle will stay. Works like a charm..especially if you have a helper to push the bolt through at the money spot.
Sent from my SM-G900W8 using Tapatalk