Calgary Jeep Association

Author Topic: Factory JK Wheel question  (Read 1094 times)

0 Members and 1 Guest are viewing this topic.

Offline Mudhawg

  • Talks waaay too much!
  • Posts: 1747
  • Rig Life
Factory JK Wheel question
« on: January 17, 2011, 03:17:14 PM »
was wondering if anyone knows what the backspacing is on a factory JK wheel as well as how large the center hole is?

thanks in advance
1984 Chevy 6" Lift 40" Boggers

Offline silverfox

  • That CB Yapper
  • Posts: 612
  • drawrof og nac enoyna
Re: Factory JK Wheel question
« Reply #1 on: January 17, 2011, 03:34:20 PM »
6.25" on the back spacing as for the center bore diameter I don't have a clue
2018 JLU Lifted on 37's

Offline Zombie

  • UberWheeler
  • Posts: 398
  • Jeff the Zombie Jeep
Re: Factory JK Wheel question
« Reply #2 on: January 18, 2011, 07:52:02 AM »
I could try to remember to look that up at work later today, try I repeat, I have a really bad memory sometimes ;)
97 Red XJ, 4.5", 31" mud's, ARB front, 9500lb winch, bushwhacker's, warn sliders, HnT SYE and CV drive shaft - written off and sold for parts :(

Offline 78ram

  • Baby Wheeler
  • Posts: 59
Re: Factory JK Wheel question
« Reply #3 on: January 31, 2011, 10:04:29 PM »
so far i've read the center bore to be 70mm(roughly 2 3/4''or 13/16'') or so......i'd need the center bore to be 3''