Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Anyone Know a Good Machine Shop?  (Read 1491 times)

0 Members and 1 Guest are viewing this topic.

Offline Jrama

  • That CB Yapper
  • Posts: 923
Anyone Know a Good Machine Shop?
« on: March 06, 2017, 10:03:24 AM »
Getting everything in place for my stroker, can anyone recommend a good shop to bore, and deck the block etc.?

Cheers

Logged

Offline hps4evr

  • Administrator
  • Talks waaay too much!
  • Posts: 2959
Re: Anyone Know a Good Machine Shop?
« Reply #1 on: March 21, 2017, 01:10:59 PM »
D&W
Logged
YJ=Y’all Jealous

Offline ngrover

  • Stocker
  • Posts: 11
    • Xpedition XJ-Eh!
Re: Anyone Know a Good Machine Shop?
« Reply #2 on: March 24, 2017, 05:06:42 PM »
I'd like to hear more about your stroker build! What crank/parts/compression you are aiming for etc.
Logged

Offline Jrama

  • That CB Yapper
  • Posts: 923
Re: Anyone Know a Good Machine Shop?
« Reply #3 on: March 25, 2017, 08:44:02 PM »
Jeep 4.2L 3.895" stroke crank
Jeep 4.0L 6.125" rods
Custom Hypereutectic +0.030" bore pistons, dish volume 24cc (Moly rings)
9.3:1 CR Static Compression ratio (6.7:1) dynamic ratio @ elevation)
<Stage 1 Cam Kit 263/265
.427/.438 Lift
LSA 114 >
Stock HO cylinder head
Mopar/Victor 0.043" head gasket
0.043" quench height (Close to zero as possible Deck height)
 '99-'00 Chevy LS1 26.2lb/hr injectors
« Last Edit: March 25, 2017, 08:48:42 PM by Jrama »
Logged
Pages: [1]   Go Up
« previous next »