Calgary Jeep Association

Author Topic: Graveltravels tinworm CJ 7  (Read 158 times)

0 Members and 1 Guest are viewing this topic.

Offline Graveltravels

  • Winch Wench
  • Posts: 48
Re: Graveltravels tinworm CJ 7
« Reply #15 on: April 18, 2018, 04:15:27 PM »







Sent from my iPhone using Tapatalk

Offline Graveltravels

  • Winch Wench
  • Posts: 48
Re: Graveltravels tinworm CJ 7
« Reply #16 on: April 18, 2018, 04:19:47 PM »
So, cutting up my poison Spyder corners to fit around the tube fenders. I have to fill in and weld up the drivers side fuel door, and cut one in the passenger side. I'm also planning to get the tailgate bolted in, and the supports welded in.

Running the exhaust, and getting it to dump out the back, the po had it dump in front of the rear axle, right in the brake lines and housing. And, my FI-Tech showed up!! So I'll be running a new fuel line for that. I also picked up a 700r4, and ordered the adaptor for the Dana 300. Figured I may as well get it done while the body is off.


Sent from my iPhone using Tapatalk