Calgary Jeep Association
4x4 Related Groups => General Talk => Topic started by: Mudhawg on June 16, 2009, 06:09:02 PM
-
i know its not a jeep but im lovin the new seats i put in my truck
(http://photos-g.ak.fbcdn.net/hphotos-ak-snc1/hs085.snc1/4902_192375080230_509325230_7197310_1149037_n.jpg)
-
looks good man, was it hard?
-
was relatively simple i had to make 4 plates and drill a couple holes to get the seats onto the sliders but only took me about 2 hours to do both seats this morning
-
doug, this is that jimmy that was out front your house correct? if so sweet you putting 2 more in the back?
-
Looks good buddy, good job!
So it is tied into plates that sandwich the floor boards?
-JW
-
Yes this is the one out front of my house im going to just keep the factor bench in the back or ditch it all together, Joey the sliders are in the factory location on the front and the rear have 2.5" wide washers double stacked on the bottom of the floor and a large washer on the top of the floor as well
-
So your coming out to run a few trails with us again this weekend?
:)
Give me a shout if you got questions,
Joey
-
Were gunna be camped back in the field by the gravelpit Joey if i had tires id come but those baby bald tires on it aint gunna make it to far haha should come by and take me for a rip in the jeep :P