Calgary Jeep Association

4x4 Related Groups => Tech Talk => Topic started by: Rubi03 jef on February 16, 2010, 04:22:26 PM

Title: axle shafts and GEARs
Post by: Rubi03 jef on February 16, 2010, 04:22:26 PM

im sure there are plenty of you that have done the up grade

so ill ask 

i have a 04 rubicon with dana 44 front and rear    looking to up grade

SUPERIOR axle makes front and rear shafts

so does
TEN FACTORY 

now the question is what is better or are they pretty much the same quality

on another note  i have to do gears and  bearings and i checked out northridge site and they have some good kits .
whos running SUPERIOR gears and bearings and how hard are these to be installed

Title: Re: axle shafts and GEARs
Post by: Bnine on February 17, 2010, 07:28:32 AM

Just go with whichever northridge recommends. Either one will get the job done, and northridge is very good with warrenties.

Superior has an americam made line of shafts, but they are very expensive compared to the made in india Alloy (Ten Factory) stuf.