Calgary Jeep Association

4x4 Related Groups => Tech Talk => Topic started by: Mr Tim on May 09, 2010, 12:58:40 PM

Title: Tool needed
Post by: Mr Tim on May 09, 2010, 12:58:40 PM

Anyone have the tool for setting the carrier preload on a 8.25 that I could borrow? Or perhaps a torsion bar so I can make my own?

Title: Re: Tool needed
Post by: Bnine on May 10, 2010, 07:44:44 PM

36mm nuts off unit bearings work. Weld a couple to a peice of tube, and "T" handle the tube at the other end.

If you weld a single it has a tendancy to slip in and catch, were as using two you can just push till it bottoms and then turn as needed.