Calgary Jeep Association

4x4 Related Groups => Tech Talk => Topic started by: nobody on October 04, 2010, 06:04:47 PM

Title: diff help
Post by: nobody on October 04, 2010, 06:04:47 PM

Are the pinion bearings hard to change in a 95 yj

Title: Re: diff help
Post by: vantagetes on October 04, 2010, 08:02:43 PM

Uhh what was wrong with the answer in here?

http://forum.calgaryjeep.com/index.php?topic=20060.0

Title: Re: diff help
Post by: nobody on October 04, 2010, 08:59:35 PM

no that was all good sorry bout that one..........what I was wanting to ask after i take drive shaft off then the yoke nut can the bearing be taken out or does a guy need to pull axles

Title: Re: diff help
Post by: FiEND on October 04, 2010, 09:05:05 PM

you need to pull the axles and the innards of the pumpkin then brass punch/hammer out the old races, brass punch/tap in new ones.  this may affect preload.  some diffs use crush sleeves so lots of torque required.  also need new pinion nut and seal.  it isn't a lot of work if you have the tools and done it before.  if not, can take a good amount of time.

Title: Re: diff help
Post by: nobody on October 04, 2010, 09:11:56 PM

well if I have it all apart maybe i will put in a posi thanks for your help pal how does one become a member of this club I mean more then on here and where does one pay his dues?

Title: Re: diff help
Post by: Immortal on October 04, 2010, 09:14:05 PM

http://forum.calgaryjeep.com/index.php?topic=8466.0