Calgary Jeep Association

General Forums => Chit-Chat => Topic started by: binare on February 25, 2013, 04:45:54 PM

Title: Steel plate
Post by: binare on February 25, 2013, 04:45:54 PM

Looking to get some 1/4 steel plate to make a couple tuning plates for one of my smokers. Where's a good place to pickup small pieces from? Need about 6 square feet roughly.

Title: Re: Steel plate
Post by: specialk on February 25, 2013, 05:29:34 PM

metal supermarket....  take lube with you....

Title: Re: Steel plate
Post by: SwampSinger on February 25, 2013, 06:29:46 PM

Quote from: binare on February 25, 2013, 04:45:54 PM

Need about 6 square feet roughly.

get some heavy duty lube...

Federal Metal might also sell you 6quare feet... see what they have.

Title: Re: Steel plate
Post by: hps4evr on February 25, 2013, 07:21:34 PM

I bought a 4x4 sheet of plate from federal. Not sure on 6x6 though.

Title: Re: Re: Steel plate
Post by: binare on February 25, 2013, 07:52:32 PM

More like 2x3, 6x6 would be 36 square feet. Thanks guys I'll try Federal. Or if anyone's got scrap kicking around, I'll pay ya back in some Damn fine ribs :-)

Title: Re: Steel plate
Post by: .:.Dingman.:. on February 25, 2013, 10:45:03 PM

I might have some I'll check tomorrow.

Dingman

Title: Re: Re: Re: Steel plate
Post by: binare on February 26, 2013, 08:47:51 AM

Quote from: .:.Dingman.:. on February 25, 2013, 10:45:03 PM

I might have some I'll check tomorrow.

Dingman

Nice! Gratzi

Title: Re: Steel plate
Post by: Corbitto on February 26, 2013, 08:41:12 PM

dont know if it helps but I have lots of 1/4" by 6" flat bar. have probably 20' or so.