Calgary Jeep Association

4x4 Related Groups => Tech Talk => Topic started by: SuicidalPenguin on August 27, 2006, 02:56:36 PM

Title: Lunchbox Lockers
Post by: SuicidalPenguin on August 27, 2006, 02:56:36 PM

I'm in the middle of putting in a Lock Right locker, but i can't get the shaft that holds the spider gears out.  I popped the cover to find no bolt, but the shaft will not budge, tried just pushing on it, tried a punch and hammer.  Is there something i left out to getting the shaft out? I can stick stuff into the bolt hole and it goes all the way through, so i don't think the PO broke the bolt and it's still in there.

Oh yeah, it's the D35 c-clip diff

Title: Lunchbox Lockers
Post by: Mac13 on August 27, 2006, 05:06:23 PM

I just put an aussie locker in my 35 and there was a small bolt holding the pinion shaft in.  I removed it and the shaft came right out

Title: bolt
Post by: bae146 on August 27, 2006, 05:14:53 PM

I believe it is 10 mm 12 point right?

Title: Lunchbox Lockers
Post by: HBZ on August 31, 2006, 05:50:29 PM

You may have to use a punch and drive a roll pin out of the case to remove the shaft if you do not have a bolt.

Good luck.

 :D  :D