Calgary Jeep Association
4x4 Related Groups => Tech Talk => Topic started by: TaTtOo on November 23, 2006, 09:07:47 PM
-
Anyone have any idea why my 4wd would stop working out of the blue? When I switch to 4 high nothing happens and when I switch to 4 lo it seems to be 2 lo. And the 4wd light is not coming on now (i guess because it is not engaging). Any ideas?
Cheers
Lawrence
-
that is the front axle disconnect vacumn piece of crud acting up :roll: ... crawl underneath and check to see if all you vacumn lines are still attached... it just takes one to fall off in that system and suddenly your in 2 wheel drive :shock: . if that doesn't solve it.. check to see that you didn't break the shift fork in the front axle.... been known to happen.
Eugene
should have grabbed that posilok when i still had it :P
-
Yep vacuum disconnect. I had the same problem, but I was able to my hands on a free one. Anyways here is a link to check out
http://www.4bangerjp.com/forums/viewtopic.php?t=506
It should enlighten you on all things vacuum disconnect
-
Yep vacuum disconnect. I had the same problem, but I was able to my hands on a free one. Anyways here is a link to check out
http://www.4bangerjp.com/forums/viewtopic.php?t=506
It should enlighten you on all things vacuum disconnect
You have to log in for that link.
-
Yep vacuum disconnect. I had the same problem, but I was able to my hands on a free one. Anyways here is a link to check out
http://www.4bangerjp.com/forums/viewtopic.php?t=506
It should enlighten you on all things vacuum disconnect
You have to log in for that link.
So whats you point. If you want a bunch of GOOD info, then register 8)
-
There's GOOD things about 4 bangers? :lol:
-
Damm, bite my tongue - that's a good site. :)
-
WOW I wish everything was as easy to fix......... the hoses were lose... done thx for the speedy replies
Cheers
Lawrence