Calgary Jeep Association
4x4 Related Groups => Tech Talk => Topic started by: 4PLAYZJ on June 21, 2007, 09:56:12 PM
-
I went for the first drive in my jeep and it seemed pretty good considering the radical change but it was a little tippy. I think that part of the problem is that I could not get the front sway bar at the stock angle. I installed jks extended lower sway bar mounts and my dissconnects are extended as much as I can(6 inches). I purchased some drop brackets that will drop the sway bar 2" down and then I can get my proper angle. My question is has anyone used drop brackets like this before? I am worried about wrecking my frame. Here are the brackets:
(http://rustysoffroad.com/mm5/media/suspension/sw-25.jpg)
I beefed them up by wending some square tubing in the center so I know that the brackets will be o.k. I just dont want to tear the welded pal nuts out of my frame. Any advise would be great or am I just not used to driving this monster and a little tippy is normal with a 9 inch lift?