Calgary Jeep Association
4x4 Related Groups => Build Ups => Topic started by: new2jeepguy on November 23, 2012, 12:27:51 PM
-
I,m going to get a J.D. squared model 3 tube and pipe bender.To recover some of the cost if anyone needs some bending,simple stuff ,I could do it. fancy intricate bends not right away, but if your good at it already I.d be prepared to let you use it in my garage where I.ll have it mounted to the floor properly and maybe learn fron you.Any interest.? I,m thinking of buying a least 2 dies a 2 inch and a 1/3/4 It will do dom tube I have a 1 inch bender already , should be good for gussetts or grab handles etc haven,t tried it yet. I,m so excited to start building my roll cage reinforcement stuff, rocker guards etc I,m gonna die. Should be getting it as soon as I convince the wife that if I don,t I may start looking at an exotic car from the states . I,m gonna tell her a found a nice corvette for 35000$ that I like, that should do it . we,ll see HMMMM 1200$ bender or 35000$ toy Learnin how to play the game with my boss
-
Learning 35000 is a big mistake to throw out there lol.
Do what I do I buy the item then say it was on sale and would it be better to buy it for 3000 or 1500 half price lol. I might be intriated in some bending also how much would ya charge?
-
depends on how much material you have to bend i guess im a reasonable guy im not out to make my million, just wanna share the tool [ and its cost] i,ll post when i get the bender