Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Trans case bearing  (Read 792 times)

0 Members and 1 Guest are viewing this topic.

Offline Marco

  • UberWheeler
  • Posts: 374
Trans case bearing
« on: November 06, 2008, 04:39:50 PM »
Hey all, just wondering if i can change front output shaft bearing on the t case without removing the whole thing?i ran it super low on fluid and now that shaft moves up and down quite a bit. i believe it is np231j
Logged
locked and loaded

Offline BlackYJ

  • Talks waaay too much!
  • Posts: 3392
    • http://www3.telus.net/ccjc/page0002.html
Re: Trans case bearing
« Reply #1 on: November 07, 2008, 08:09:07 AM »
If you ran it super low on fluid I would be inclined to open up the t-case and have a look.  I have personally experience the wrath of no oil being splashed around in the t-case.
Logged
'95 YJ with a few mods

Offline rws

  • CJA Members
  • Talks waaay too much!
  • Posts: 1543
  • Stump Grinder
Re: Trans case bearing
« Reply #2 on: November 07, 2008, 10:27:34 AM »
They are not that difficult to remove.
Logged

Offline Marco

  • UberWheeler
  • Posts: 374
Re: Trans case bearing
« Reply #3 on: November 07, 2008, 01:25:02 PM »
ok thanks! i have the chrysler service manual for it so maybe ill tackle it.
Logged
locked and loaded
Pages: [1]   Go Up
« previous next »