Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: diamond plate bending  (Read 960 times)

0 Members and 2 Guests are viewing this topic.

JUC 169

  • Guest
diamond plate bending
« on: May 06, 2009, 09:54:26 PM »
I was wondering how hard would it be to bend a piece of diamond plate to use as a skid plate under a CJ fuel tank.  Would anyone have any insight as to how much it would cost?  Or where I could get it bent?  Ideally I'd like to find someone who can do it for a reasonable price...
Logged

Offline esi

  • That CB Yapper
  • Posts: 633
Re: diamond plate bending
« Reply #1 on: May 06, 2009, 10:11:19 PM »
Diamond plate is no harder to bend than normal plate. Is there a reason you want diamond plate? I would want a smooth skid plate, not a grippy one.
Logged
Formerly of Boots & Boost Inc
Back farming and fabricating again.

Offline sn4cktime

  • UberWheeler
  • Posts: 321
Re: diamond plate bending
« Reply #2 on: May 07, 2009, 01:19:47 PM »
Maybe call up Frontier Fabrication.  They have an awesome break.  Maybe they'll do it for a couple bucks.
Logged
----1988 AMC Eagle, mostly a flat XJ at this point----

Offline .:.Dingman.:.

  • That CB Yapper
  • Posts: 584
Re: diamond plate bending
« Reply #3 on: May 07, 2009, 09:07:52 PM »
check with grant metal products.  great bunch of people there
Logged

Offline Marco

  • UberWheeler
  • Posts: 374
Re: diamond plate bending
« Reply #4 on: May 09, 2009, 07:48:56 PM »
i made a skid plate for my old jeep the same way. scored the back of it with a grinder so it bends easy(dont score alot as to weaken it) then bent it on the tool bench. seemed to work ok.
Logged
locked and loaded
Pages: [1]   Go Up
« previous next »