Login with username, password and session length
0 Members and 1 Guest are viewing this topic.
Hey, I was wondering if anyone going to the off-road 101 has a swr meter and would be willing to give me a hand to tune my cb before we get started.Cheers,Brad
I have to work on noise reduction. My reception seems fine until I turn on the key and can hear every computer, wiper, motor, ignition etc. start up. So much noise, it takes a good signal to get past the noise and therefore the squelch. Just remember, unless you have a tuneable antenna, tuning can get somewhat complicated. I have a meter and am in the NE.PS: There doesn't seem to be a lot of traffic on CB in Calgary lately, but despite a low SWR, perhaps my rig has poor reception.Sounds like you have a bad ground somewhere. You might want to try and run right to the frame or something like that, unless you have already tried that. When you key up your mic watch your meter on your radio, the needle should not hit the end you want to adjust it with your swr knob so that it is just in the green while you are keyed up on the mic. Now just tune the squelch out easy and all is good.If you really want good cb coverage go and see the radio guy over at the road kill truck stop and get yourself a galaxy radio pricey but good radios work really well in the Rockies.