Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Post lift jeep doesn't like 2nd and reverse  (Read 583 times)

0 Members and 2 Guests are viewing this topic.

Offline Jrama

  • That CB Yapper
  • Posts: 923
Post lift jeep doesn't like 2nd and reverse
« on: July 06, 2009, 09:56:45 PM »
I just installed a BDS 3 inch lift on my TJ, Everything is fine except now the shift lever hangs down towards 4 th slightly in neutral and tends to pop out of 2nd on occasion (only when first putting it in)  and reverse just sucks. Basically every gear you have to shift back towards the rear bumper (2nd, 4th and R) , seems strained to stay in. It is annoying and probably not good for long term wear and tear. Of course this issue was a direct result of dropping the T case. Does anyone have any solutions for this problem?  ???

Any answers or advise are greatly appreciated
Logged

Offline WhiteOut

  • Talks waaay too much!
  • Posts: 1885
Re: Post lift jeep doesn't like 2nd and reverse
« Reply #1 on: July 06, 2009, 09:59:59 PM »
Standard transmission right?  IIRC the solution to this is trimming the boot on the shifter, the re should be a thread on jeepforum about it
Logged

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
Re: Post lift jeep doesn't like 2nd and reverse
« Reply #2 on: July 07, 2009, 08:29:41 AM »
Pull the boot and trim the sheet metal were the shifter hits.
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]
Pages: [1]   Go Up
« previous next »