Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Vibration  (Read 1179 times)

0 Members and 1 Guest are viewing this topic.

Offline vantagetes

  • That CB Yapper
  • Posts: 947
  • Edmonton Trail Rated
Vibration
« on: January 21, 2012, 05:42:37 PM »
I have a vibration somewhere in my jeep that is still there but less severe in 4wd (to the point where it's hard to tell it's there). It starts in second gear (or really high rev 1st) and continues up into highway speeds. During no load (between acceleration and deceleration) it appears to go away.

So far everything seems to be nice and tight. I disconnected the front drive shaft and it's still there, haven't taken the back one off yet but the fact that it seems to get better with 4wd makes me question if I can even notice the difference when it's disconnected or not.

Ideas?
Logged

Offline Tyn Pow

  • Budget Lift
  • Posts: 196
Re: Vibration
« Reply #1 on: January 21, 2012, 10:29:23 PM »
Take both driveshafts off and drive around, this will help to pinpoint your vibe.
Logged

Offline Vinman

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2237
Re: Vibration
« Reply #2 on: January 21, 2012, 10:36:39 PM »
Quote from: Tyn Pow on January 21, 2012, 10:29:23 PM
Take both driveshafts off and drive around, this will help to pinpoint your vibe.

Very important you take them both off at the same time.
Logged
/l ,[____],
 l---L -OlllllllO-
 ()_)-()_)-o-)_)

Quote from: Bnine link=topic=25904.msg162940#msg162940      date=1341881306
. 
 Resident prick is my job and it took me ten years to earn that title

Offline frenchy

  • Talks waaay too much!
  • Posts: 1417
Re: Vibration
« Reply #3 on: January 21, 2012, 10:45:33 PM »
Sounds like rear carrier bearings.
Agreed, Remove both driveshafts and re test.
Logged
Jeep
With stuff

Offline vantagetes

  • That CB Yapper
  • Posts: 947
  • Edmonton Trail Rated
Re: Vibration
« Reply #4 on: January 22, 2012, 11:55:52 PM »
Oh good, it sounds like you guys are coming over to help. And by help I mean push while we are testing.
Logged

Offline Rubi03 jef

  • Talks waaay too much!
  • Posts: 1918
  • she never understands
Re: Vibration
« Reply #5 on: January 23, 2012, 12:24:19 AM »
check all the u joints in the rear shaft ..  then remove the shaft .. leave the front and go for a drive ..
Logged
04 rubicon <4'' X series RC lift, 1.25'' RC body lift, 1'' RC MML, CV rear drive shaft,  Stubby front bumper, CB,35 MTZ" ,Hi Lifter 54'',LED tail lights , flat fenders, LED front Flasher, half doors, Light force spots, and CDN M101 custom Military trailer
Pages: [1]   Go Up
« previous next »