Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Bumper Build  (Read 2653 times)

0 Members and 1 Guest are viewing this topic.

Offline Marco

  • UberWheeler
  • Posts: 374
Bumper Build
« on: March 05, 2013, 01:10:26 AM »
Hey guys/gals, does anyone know of a local spot i can find some weld on tabs for my bumper? id like to include a couple of shackles hanging for recovery spots.thanks!
Logged
locked and loaded

Offline Corbitto

  • Budget Lift
  • Posts: 129
Re: Bumper Build
« Reply #1 on: March 05, 2013, 08:54:26 PM »
i built my own and have some extras.  I have 4 - (3/4" thick 2x3 lugs with 7/8 holes) and I have 1" thick  pieces that are 2.75 x 3". just a pilot through the centre.  could whip you up some
Logged

Offline dubbleJs

  • Talks waaay too much!
  • Posts: 1330
Re: Bumper Build
« Reply #2 on: March 06, 2013, 10:20:21 AM »
Princess Auto sells 1" thick tabs as well
Logged
'91 XJ - 3" procrap - cutout for 33" MT's  - More and more dents every run...Sold.
'98 XJ - Lifted, locked and lovin' it

Offline esi

  • That CB Yapper
  • Posts: 633
Re: Bumper Build
« Reply #3 on: March 06, 2013, 04:15:54 PM »
If you're going to cut some. I like to make a bit of a lip on the backside the tab. Then cut a hole in the bumper for the piece to slide through. Then weld it. That way you have the lip plus the weld taking the stress of the pull. Just my two cents
Logged
Formerly of Boots & Boost Inc
Back farming and fabricating again.

Offline Marco

  • UberWheeler
  • Posts: 374
Re: Bumper Build
« Reply #4 on: March 06, 2013, 06:25:35 PM »
awsome thanks. ill pm you corbitto and grab a couple when im back in town. cheers
Logged
locked and loaded

Offline Corbitto

  • Budget Lift
  • Posts: 129
Re: Bumper Build
« Reply #5 on: March 06, 2013, 07:46:20 PM »
ok
Logged
Pages: [1]   Go Up
« previous next »