Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Unit bearings  (Read 1056 times)

0 Members and 1 Guest are viewing this topic.

Offline MOABICON

  • Budget Lift
  • Posts: 199
  • MOABICON
Unit bearings
« on: June 08, 2014, 08:10:07 PM »
When I jack up the front axle. Grab the wheel at the 12 and 6 or
the 9 and 3 positions and try and move it. The unit bearing has
a "wee bit of play" ( 1/16 of and inch ).
Should have none, or is this acceptable? No noise when driving.
2003 Jeep TJ Sahara
Logged
03 TJ, 4" lift, 33's, Eaton eLockers- Front & Rear, winch, CB

Offline raf2379

  • That CB Yapper
  • Posts: 752
Re: Unit bearings
« Reply #1 on: June 08, 2014, 09:02:31 PM »
should have no play in the unit bearing, what about the ball joints? any play
Logged

Offline MOABICON

  • Budget Lift
  • Posts: 199
  • MOABICON
Re: Unit bearings
« Reply #2 on: June 08, 2014, 09:12:41 PM »
No play in the ball joints. All in the unit bearing
Logged
03 TJ, 4" lift, 33's, Eaton eLockers- Front & Rear, winch, CB
Pages: [1]   Go Up
« previous next »