Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: What did I fish out of my bellhousing  (Read 1957 times)

0 Members and 1 Guest are viewing this topic.

Offline fony3

  • UberWheeler
  • Posts: 404
What did I fish out of my bellhousing
« on: September 02, 2015, 06:48:24 PM »
The jeep has been getting a bit tougher to get in gear, decided to check out the clutch hydraulic system. In my messing around, the rod from the slave fell inside. Today I attempted to fish it out with a magnet and came up with this instead. I cant place it.
Pardon the oil, the RMS is getting changed this weekend, now looks like maybe a new clutch too? arg...

Jeep: 02 TJ . NV3550

« Last Edit: September 02, 2015, 06:58:47 PM by fony3 »
Logged

Offline fony3

  • UberWheeler
  • Posts: 404
Re: What did I fish out of my bellhousing
« Reply #1 on: September 02, 2015, 08:07:14 PM »
Also is it possible to pull the inspection plate without sliding the transmission back?
Logged

Offline Uboatcmdr

  • Budget Lift
  • Posts: 186
Re: What did I fish out of my bellhousing
« Reply #2 on: September 03, 2015, 12:13:23 AM »
looks like part of the throw out bearing to me? Not too sure though.
Logged

Offline fony3

  • UberWheeler
  • Posts: 404
Re: What did I fish out of my bellhousing
« Reply #3 on: September 06, 2015, 10:16:19 AM »
As i suspected as well, it was a part of the TOB. Here is a comparison of the new one I put in yesterday and the busted up one I pulled. Both are Luk.

Also I have a rogue spring from the clutch job, can anyone identify its home? Thanks! Wondering if this is from my Tcase Shifter boot. it was pretty beat up.



« Last Edit: September 06, 2015, 10:33:29 AM by fony3 »
Logged
Pages: [1]   Go Up
« previous next »