Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: 4.2l  (Read 866 times)

0 Members and 1 Guest are viewing this topic.

ramitkamloops

  • Guest
4.2l
« on: December 02, 2006, 05:25:26 PM »
hey anyone know about putting a 4.0l head on a 4.2l motor or a site to go to
Logged

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
4.2l
« Reply #1 on: December 02, 2006, 08:42:54 PM »
Go search pirate, and you will find lots of info.

BC4x4 would probably have a few articles as well.

I know there is a little bit of customization involved. Blocking off some water jackets and what not.

hth
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]

Offline Gearhead

  • Talks waaay too much!
  • Posts: 1161
4.2l
« Reply #2 on: December 02, 2006, 09:48:19 PM »
A good hotrod alteration ! , however  it's not advisable to do this on an engine that is high milage unless .......... it's done during an overhaul , involving  a rebore etc. It's a good time to go with a cam / lifter swap too.
Logged

Offline calltrex

  • Talks waaay too much!
  • Posts: 1398
4.2l
« Reply #3 on: December 02, 2006, 11:34:16 PM »
You will have to do some slight modifications and not sure if its really worth it. I almost did that but didnt.

Put your money into a howel injection and it will be much more use to you..
Logged
........___________
.......//.......""""......\\
....=//___________\\=
.....(@)___JEEP_(__@)
......\____I===I____/
.../""""/........J
../""""/=(=)___....../""""/
./___/............==/""""/
....................../___

ramitkamloops

  • Guest
4.2l
« Reply #4 on: December 29, 2006, 12:36:30 AM »
Thanks i found a 96 4.0liter head with everthing i need for $450 and the howell efi is $1200 us. The bottom end on motor was done not long ago but the top is shot so this will work thanks
Logged
Pages: [1]   Go Up
« previous next »