Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Lifters, not going back in!!!!  (Read 754 times)

0 Members and 1 Guest are viewing this topic.

Offline BUKI

  • Talks waaay too much!
  • Posts: 1197
  • Project Fugly
Lifters, not going back in!!!!
« on: July 28, 2008, 04:35:03 PM »
Ok here's the thing I had a bad lifter (serious ticking) during start up at first.  Then got worse as time went on.  So I ended up buying a set to replace them all.  That was over a month ago.  I finally got the time to do them today.  So I started pullin em all.  The first 3 went in soooo easily, BUT now im stuck on the middle 2 (from front to back).  they just dont to go in.  Does anyone have any ideas or tricks???? Because im completly confused and tapped out.
Logged

yjcanibul

  • Guest
Re: Lifters, not going back in!!!!
« Reply #1 on: July 28, 2008, 07:14:44 PM »
hey Buki,  guess = try putting them in the freazer overnight and turn crank another 1/2  ... or micro - measure 'em all to be same size ...

hope this or another post helps ...


Logged

Offline BUKI

  • Talks waaay too much!
  • Posts: 1197
  • Project Fugly
Re: Lifters, not going back in!!!!
« Reply #2 on: July 28, 2008, 10:44:11 PM »
ha,  you read my mind.  After I made this post i did just that.  It worked.
thanx for posting
Logged

stoggy97tj

  • Guest
Re: Lifters, not going back in!!!!
« Reply #3 on: August 04, 2008, 10:33:13 AM »
Good thing you got here before me..... my suggestion woulda sucked because 18"drift + hammer =trouble  :P
Logged
Pages: [1]   Go Up
« previous next »