Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Wheel Spacers  (Read 944 times)

0 Members and 1 Guest are viewing this topic.

Offline JKrider

  • Stocker
  • Posts: 1
Wheel Spacers
« on: July 29, 2011, 07:35:31 PM »
Hey guys, fairly new here but a jeep nut all the same. I'm looking at possibly installing a set of Spidertrax wheel spacers on my jeep. Any thoughts on whether they're safe or might wear out steering parts? (was told they would by a certain 4x4 shop) Spidertrax website claims their perfectly safe if installed properly and there's no evidence of them wearing out parts. Who's right?  :-\
Logged

Offline TL-Iguana

  • Talks waaay too much!
  • Posts: 1117
  • XJ - The Official TJ Rescue Vehicle
Re: Wheel Spacers
« Reply #1 on: July 29, 2011, 10:58:27 PM »
If installed correctly you should probably not have to worry. If installed incorectly, then you will definately have issues. Your now adding an inch to the end of your axles, and yes this will create more strain on your steering. Perhaps not enough to cause any problems or degradation of components, but once you get into larger tires and whatnot, then yes your going to be going through more u-joints and bearings. Its a fact of life and physics. Good choice however on the Spidertrax.


Here is some recently posted, very good information about Spidertrax spacers too.

http://forum.calgaryjeep.com/index.php?topic=22371.msg137592#msg137592

Logged
I did a Google search for "hot trannies" but nothing came up about oil coolers  :o

Worrying too much about mpg with a Jeep is similar to worrying about your sister's virginity. An ok thing to be concerned about but...

'01 XJ on 35s, '11 Jk DD

Offline tubby

  • Talks waaay too much!
  • Posts: 1349
  • Life's too short for a fulltime job
Re: Wheel Spacers
« Reply #2 on: July 29, 2011, 11:17:06 PM »

Do a search  on wheel spacers on this forum and many others and it will make your head hurt. I wasn't a fan of wheel spacers(not talking bout the el-cheapo sandwich type) a few years ago, but I had rims with the wrong backspacing. I purchased some Spidertrax ones and have logged over 10,000kms on the highway and offroad.

Read the instructions and have a properly calibrated torque wrench. Torque to spec and re-torque after 100-200kms or whatever your instructions say to do. Check periodically when you have a wheel off your vehicle.
Logged
Lockers
Cuz ya can't kick arse with only one leg

Offline Raspberry

  • Budget Lift
  • Posts: 299
  • Do what you love, the rest will follow.
Re: Wheel Spacers
« Reply #3 on: July 30, 2011, 12:19:02 AM »
I currently run 2" spacers all the way around on my XJ. Yes, with big MEATY mud tires installed, the spacers will slightly quicken the rate at which you go through certain front-end components.

However as tubby said, they are a quick and easy way to stuff out your wheels if you have rims of an undesirable backspacing (as I did).
Logged
DECEASED - 'Big Ben' (black '97 XJ) : ~9" lift - 35's - Ford 9" - 4.56 gears - armoured up - ...and a sound system that can annoy the hell out of Lemon-aid Jay!!
NEXT - Dark green '98 XJ to build up....

Offline Zombie

  • UberWheeler
  • Posts: 398
  • Jeff the Zombie Jeep
Re: Wheel Spacers
« Reply #4 on: July 30, 2011, 01:17:53 AM »
it will eat them up quicker, but it will not be any different on components than a wheel with a higher offset(sits farther out).
so if installed properly, you should be ok.

that being said, I don't like them that much.

Logged
97 Red XJ, 4.5", 31" mud's, ARB front, 9500lb winch, bushwhacker's, warn sliders, HnT SYE and CV drive shaft - written off and sold for parts :(
Pages: [1]   Go Up
« previous next »