Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Nutsert Tool needed  (Read 1014 times)

0 Members and 1 Guest are viewing this topic.

Offline Labrat0013

  • Winch Wench
  • Posts: 42
Nutsert Tool needed
« on: March 28, 2012, 09:32:59 AM »
Anybody have a nutsert tool they would care to lend/rent/sell. I am installing 3/8" thread steel nutserts. I tried the bolt/oversized nut method and it is not working well.

Cheers,
Cris
Logged
2000 TJ Sport, 2.5" OME HD, 31" BFG AT, 1" MML, Rubicon Sliders

Offline Uboatcmdr

  • Budget Lift
  • Posts: 186
Re: Nutsert Tool needed
« Reply #1 on: March 28, 2012, 10:20:19 AM »
The ait tool is about 700 dollars.
try using the nut and bolt method with an impact
Logged

Offline Labrat0013

  • Winch Wench
  • Posts: 42
Re: Nutsert Tool needed
« Reply #2 on: March 28, 2012, 10:45:09 AM »
Thanks Uboat, i'll give it a try.
Logged
2000 TJ Sport, 2.5" OME HD, 31" BFG AT, 1" MML, Rubicon Sliders

Offline Labrat0013

  • Winch Wench
  • Posts: 42
Re: Nutsert Tool needed
« Reply #3 on: March 29, 2012, 02:22:54 PM »
Worked much better with the impact. Thanks again.
Logged
2000 TJ Sport, 2.5" OME HD, 31" BFG AT, 1" MML, Rubicon Sliders

Offline Uboatcmdr

  • Budget Lift
  • Posts: 186
Re: Nutsert Tool needed
« Reply #4 on: March 29, 2012, 10:45:06 PM »
Haha no worries, at my old job i was putting 100's of those into truckbeds and cargovan floors a day.
They are an absolute nightmare if you over tighten them, so be careful
Logged
Pages: [1]   Go Up
« previous next »