So I installed my 1" motor mount lift. I now have the following angles with
Both the 1" mml and the 1" t-case drop. Output 10* drive shaft 5* pinion 10*. So my next question is, do you recommend leaving everything as is or raise my t case to reduce the pinion/driveshaft and driveshaft/output angles and sacrface a bit of the output/pinion pairing? Keep in mind these angles are measured with a half tank. If i hook up my tent trailer with the current set up this would drop the rearn end making the drive shaft flatter and the pinion/drivesahft and driveshaft/output angles greater than 5*.
Any thoughts?
Cheers,
Cris
Topic: Driveline angles. (Read 3503 times)