Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: 98 xj snorkel install  (Read 831 times)

0 Members and 3 Guests are viewing this topic.

Offline Joe Dirt

  • Winch Wench
  • Posts: 39
  • Over it..Threw it.. Never around it!!!
98 xj snorkel install
« on: October 28, 2012, 01:03:58 PM »
I have a Chinese knock off snorkel. It is meant for my truck and is the Slater molded rope that runs outside my fender and up the pillar. I was wondering if there are any videos at all to show the mods I need to do.  It looks like allot.. Haha.. Any help would be appreciated.

Cheers
Logged
Joe Dirt!! That's right... You heard it... I am here.. AND I DONT DRIVE NO HEMI!!!

98 XJ - 5 1/2" lift - 33's - 10,000 lb winch - Eaton Front Diff Locker - Detroit Rear Diff Limited Slip - Rubicon springs - Dana 44 Axle/Diffs w/ Warn locks - Irock T ca

Offline apeman

  • Talks waaay too much!
  • Posts: 1012
  • not as grumpy
Re: 98 xj snorkel install
« Reply #1 on: October 28, 2012, 04:41:45 PM »
The only hard part is relocation of the washer fluid bottle.since it sits exactly where the snorkle will run under the driver side fender.
Logged
Getting grumpier every day.
99 XJ - It's got sum stuff ,Noel free stuff..
98 ZJ - It's just ugly, but bigger than your Rubi
Pages: [1]   Go Up
« previous next »