Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Steel plate  (Read 2427 times)

0 Members and 1 Guest are viewing this topic.

Offline binare

  • That CB Yapper
  • Posts: 771
Steel plate
« on: February 25, 2013, 04:45:54 PM »
Looking to get some 1/4 steel plate to make a couple tuning plates for one of my smokers. Where's a good place to pickup small pieces from? Need about 6 square feet roughly.
Logged

Offline specialk

  • CJA Executive
  • Talks waaay too much!
  • Posts: 3176
Re: Steel plate
« Reply #1 on: February 25, 2013, 05:29:34 PM »
metal supermarket....  take lube with you....
Logged
04 TJ Rubi

Offline SwampSinger

  • CJA Members
  • Talks waaay too much!
  • Posts: 6172
  • Baconator
    • mmmmm-bacon
Re: Steel plate
« Reply #2 on: February 25, 2013, 06:29:46 PM »
Quote from: binare on February 25, 2013, 04:45:54 PM
Need about 6 square feet roughly.

get some heavy duty lube...

Federal Metal might also sell you 6quare feet... see what they have.
Logged

Offline hps4evr

  • Administrator
  • Talks waaay too much!
  • Posts: 2959
Re: Steel plate
« Reply #3 on: February 25, 2013, 07:21:34 PM »
I bought a 4x4 sheet of plate from federal. Not sure on 6x6 though.
Logged
YJ=Y’all Jealous

Offline binare

  • That CB Yapper
  • Posts: 771
Re: Re: Steel plate
« Reply #4 on: February 25, 2013, 07:52:32 PM »
More like 2x3, 6x6 would be 36 square feet. Thanks guys I'll try Federal. Or if anyone's got scrap kicking around, I'll pay ya back in some Damn fine ribs :-)
Logged

Offline .:.Dingman.:.

  • That CB Yapper
  • Posts: 584
Re: Steel plate
« Reply #5 on: February 25, 2013, 10:45:03 PM »
I might have some I'll check tomorrow.

Dingman
Logged

Offline binare

  • That CB Yapper
  • Posts: 771
Re: Re: Re: Steel plate
« Reply #6 on: February 26, 2013, 08:47:51 AM »
Quote from: .:.Dingman.:. on February 25, 2013, 10:45:03 PM
I might have some I'll check tomorrow.

Dingman

Nice! Gratzi
Logged

Offline Corbitto

  • Budget Lift
  • Posts: 129
Re: Steel plate
« Reply #7 on: February 26, 2013, 08:41:12 PM »
dont know if it helps but I have lots of 1/4" by 6" flat bar. have probably 20' or so.
Logged
Pages: [1]   Go Up
« previous next »