Calgary Jeep Association

Author Topic: NOT able to put in gear.. pls help!  (Read 2135 times)

0 Members and 1 Guest are viewing this topic.

Offline JackstandJohnny

  • Talks waaay too much!
  • Posts: 4727
  • where Jeeps go to die
Re: NOT able to put in gear.. pls help!
« Reply #15 on: April 26, 2013, 11:49:49 AM »
if you haven't.......... change the fluid.  easier than a tranny swap.

start there.
~ rescue green JKUR on 35s.  typical rubicon build

Offline pooljunky

  • That CB Yapper
  • Posts: 563
Re: NOT able to put in gear.. pls help!
« Reply #16 on: April 27, 2013, 01:41:30 AM »
K 4 hours later transmission is out.. now.. change clutch and release bearing at the same time? Price check tom morning

Offline TL-Iguana

  • Talks waaay too much!
  • Posts: 1117
  • XJ - The Official TJ Rescue Vehicle
Re: NOT able to put in gear.. pls help!
« Reply #17 on: April 27, 2013, 03:03:30 AM »
If your clutch is out then yes. Change the release bearing at the same time.

I dont know much about AX15's but if the slave is internal may as well change that at the same time too... Also have a look at your flywheel since its all apart now. If theres any damage to that a new flywheel really isnt all that much either... May as well do the work now rather than later..
I did a Google search for "hot trannies" but nothing came up about oil coolers  :o

Worrying too much about mpg with a Jeep is similar to worrying about your sister's virginity. An ok thing to be concerned about but...

'01 XJ on 35s, '11 Jk DD

Offline pooljunky

  • That CB Yapper
  • Posts: 563
Re: NOT able to put in gear.. pls help!
« Reply #18 on: April 27, 2013, 11:19:29 PM »
Didnt replace the clutch but replaced the release bearing and the transmission... all is good now.. now time to rebuilt the old one.. thanks for all the input guys!