cant shift to 4l and if i get it into i cant get it out of

[rawekwit]

i am a new jeep member and i have a 3 inch body lift 6 inch suspension lift 1 inch motor mount and a high clearance skidplate and when i try and get it into 4l the bars on the 4wd bracket contact eachother and prevent fully shifting into 4l and if i get it into 4l then i can get it back to 2 high??
  maybe i need to take off the 4wd drop bracket entirely or just drill new holes for it to pivot from but im just wondering if you guys have any suggestions
thanks

[Moezer]

that's a lot of lift lol, have u tried the adjustment that you have on the jeep? im sure its not adjusted at the right hight and causing it to bind

[rawekwit]

see its scraping the correction plat where the lever is that connect to in cab 4wd shifter i believe its because the correction plat makes the center level rod thing at too great of an angle  im thinking i might just slightly bend the top of that part that holds that rod

[JENSSEN]

Get a Novak shifter cable assembly

[rawekwit]

just so you guys know i  just drilled two bolt holes approximately where it scraps and it straightened the middle lever bar and prevented scrape allowed shifting

[apeman]

3" body lift = gay. ditch it