Calgary Jeep Association

« previous next »
Pages: 1 [2]   Go Down

Author Topic: Drive Shaft questions  (Read 3592 times)

0 Members and 1 Guest are viewing this topic.

Offline BlackYJ

  • Talks waaay too much!
  • Posts: 3392
    • http://www3.telus.net/ccjc/page0002.html
Drive Shaft questions
« Reply #15 on: February 07, 2007, 01:28:44 PM »
I will trade you mine from my SYE kit.  I would like to go all 1330s on the rear driveshaft and it might work, if they are the same diameter.  Unfortunately I don't have the kit yet

Also you might want to correct your post as you mentioned the front twice
Logged
'95 YJ with a few mods

Offline fug

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2345
  • Airdrie Pick n Pull
Drive Shaft questions
« Reply #16 on: February 07, 2007, 01:43:16 PM »
I think I've been reading so much on this stuff I'm starting to get confused.

Yeah I am planning to run a 1310 yoke on the front of the TC.   The guy at DSI figured he might have one in stock but he wanted me to pull the one on there now and bring it tomorrow.  Hopefully they do have one cause I'm going through some jeep withdrawl!
Logged
Fug
TJ Rubicon

Offline fug

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2345
  • Airdrie Pick n Pull
Drive Shaft questions
« Reply #17 on: February 07, 2007, 01:48:35 PM »
Thanks for the heads up on the typo in my previous message.

I'd have no issue swaping yokes with you other than I'm pretty impatient so don't know if I want to wait.  If DSI has the correct yoke I'll probably grab it tomorrow and if you're interested in the 1330 yoke I can hang onto it for you.
Logged
Fug
TJ Rubicon
Pages: 1 [2]   Go Up
« previous next »