Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Mounting Hi-Lift  (Read 1333 times)

0 Members and 1 Guest are viewing this topic.

Jeepster

  • Guest
Mounting Hi-Lift
« on: September 09, 2008, 11:14:15 AM »
Anyone have any good tips on mounting a Hi-Lift jack to a jeep ?
I dont want to mount it on the outside of the vehicle, so any ideas on mounting it on the inside would be appreciated :)
I was thinking about mounting it just above the rear seat across from one side of the roll cage to the other.
Logged

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: Mounting Hi-Lift
« Reply #1 on: September 09, 2008, 11:56:41 AM »
Quote from: Jeepster on September 09, 2008, 11:14:15 AM
Anyone have any good tips on mounting a Hi-Lift jack to a jeep ?
I dont want to mount it on the outside of the vehicle, so any ideas on mounting it on the inside would be appreciated :)
I was thinking about mounting it just above the rear seat across from one side of the roll cage to the other.

I have an older steel Add-a-trunk in the back of my TJ and the Hi-Lift is bolted down to it. 
Logged
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html
Pages: [1]   Go Up
« previous next »