Calgary Jeep Association

« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: my rant for july  (Read 6361 times)

0 Members and 1 Guest are viewing this topic.

Offline Spinalguy

  • Talks waaay too much!
  • Posts: 2759
    • http://www.spinalguy.com
Re: my rant for july
« Reply #30 on: July 29, 2009, 10:21:19 AM »
ok, so if it is popping out more than it may be quite simple. When my 2" body lift went into my first jeep, the same thing happened. They just lengthened the bottom of the stickshift to fix it.
Bnine would be more technical on this. Did you get a t-case skid dropped as well?

Logged
sent from my old school rotary dial phone.

Offline Rubi03 jef

  • Talks waaay too much!
  • Posts: 1918
  • she never understands
Re: my rant for july
« Reply #31 on: July 30, 2009, 12:12:17 AM »
clearance isnt the issue its all been checked .. its the sincro    i think thats how you spell it .. it will stick sometimes and others it will jump right out and its even jumped out so hard that it went into 3rd

i only have a 1.25 body and my skid plate has a bit of a bend to it so its probably only .75 up

Logged
04 rubicon <4'' X series RC lift, 1.25'' RC body lift, 1'' RC MML, CV rear drive shaft,  Stubby front bumper, CB,35 MTZ" ,Hi Lifter 54'',LED tail lights , flat fenders, LED front Flasher, half doors, Light force spots, and CDN M101 custom Military trailer

Offline Spinalguy

  • Talks waaay too much!
  • Posts: 2759
    • http://www.spinalguy.com
Re: my rant for july
« Reply #32 on: July 30, 2009, 09:45:18 AM »
Quote from: Rubi03 jef on July 30, 2009, 12:12:17 AM
clearance isnt the issue its all been checked .. its the sincro    i think thats how you spell it .. it will stick sometimes and others it will jump right out and its even jumped out so hard that it went into 3rd

i only have a 1.25 body and my skid plate has a bit of a bend to it so its probably only .75 up



Well, hopefully Rob can help you out. He has done many good things for CJA peeps.
Good Luck
Logged
sent from my old school rotary dial phone.
Pages: 1 2 [3]   Go Up
« previous next »