Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Thompson Coupling  (Read 2203 times)

0 Members and 2 Guests are viewing this topic.

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Thompson Coupling
« on: November 01, 2010, 04:52:35 PM »
During my research this weekend I came across a blog feed on JEEPFORUM.COM that discussed SYE/CV for lifted jeeps.  In the article they showed a video of the Thompson Coupling drive shaft, but said nothing about where you could get it or if it was actually any good in real world conditions.

So I was wondering if any of you out there have heard of it? Or better yet have it?

Heres the link for those who are interested,
http://www.jeepforum.com/forum/f9/what-cv-shaft-why-do-i-want-one-854790/

Thanks
Logged
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.

Offline hps4evr

  • Administrator
  • Talks waaay too much!
  • Posts: 2959
Re: Thompson Coupling
« Reply #1 on: November 01, 2010, 05:34:35 PM »
ive never seen the thompson coupling before. looks good though. it reminds me of that hi end driveshaft joint set-up bthat pats driveline sells.
 http://www.patsdriveline.com/index.php/products/high-angle-cv-joints.html

similar but different. im sure the thompson coupling would work great but it needs to be sold to the mainstream oems to get put out there and available for everyone.
Logged
YJ=Y’all Jealous
Pages: [1]   Go Up
« previous next »