Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Proper Jack Stand placement under TJ  (Read 1842 times)

0 Members and 1 Guest are viewing this topic.

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Proper Jack Stand placement under TJ
« on: February 15, 2012, 09:16:42 AM »
TJs going under the knive this weekend!
I will be removing both axles and was hoping to get a little more info on where to properly place the jack stands under the vehicle.  Because of the size of my garage the intention is to do one axle at a time by removing the front, putting everything back together, rolling the jeep out, turning it around and then removing the back. 
Any info will help as I don't feel like getting smushed!!  :-\
Logged
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.

Offline 03Jeeper

  • Budget Lift
  • Posts: 266
Re: Proper Jack Stand placement under TJ
« Reply #1 on: February 15, 2012, 09:40:46 AM »
If you can only remove one axle at a time then place the stands right after the lower control arm mount on the frame. For the rear, right in front of the lower control arm mount. 

To add a sense of more security, throw the tires under the skidplate.
Logged

Offline jkrubi

  • Budget Lift
  • Posts: 262
Re: Proper Jack Stand placement under TJ
« Reply #2 on: February 15, 2012, 09:45:02 AM »
On the frame somewhere, I'd put them behind of the axle ( more towards the middle of the jeep) so I could pull it out from the front of the jeep. But before I took anything out I'd push/shake the jeep as hard as I can to make sure it's steady. If you got a set of 4 put the other 2 up near the front but make them removable.
Be safe under there
Logged

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Re: Proper Jack Stand placement under TJ
« Reply #3 on: February 15, 2012, 11:56:32 AM »
I for sure will be putting the spare under the t-case skid plate learned this trick first time I went under.  So there is no need to put stands up at the front of the frame where the bumber attaches?
Logged
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.

Offline 03Jeeper

  • Budget Lift
  • Posts: 266
Re: Proper Jack Stand placement under TJ
« Reply #4 on: February 15, 2012, 12:01:12 PM »
Quote from: FirstTimer on February 15, 2012, 11:56:32 AM
I for sure will be putting the spare under the t-case skid plate learned this trick first time I went under.  So there is no need to put stands up at the front of the frame where the bumber attaches?

You don't have to, but you can.
Logged

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
Re: Proper Jack Stand placement under TJ
« Reply #5 on: February 15, 2012, 01:08:42 PM »
I always leave a jack under the rig somewhere in tension just case. Typically under the bumpers when Im removing axles.

If just doing axle work, I use a redundant set of stands under the axle in addition to the ones under the frame.

I work alone a lot, and I have dropped vehicles before. Luckily never when I was under one.

Anyways, better safe then sorry.
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Re: Proper Jack Stand placement under TJ
« Reply #6 on: February 15, 2012, 01:37:33 PM »
Perfect, thanks for the advice!

Quote from: Bnine link=topic=24712.msg154748#msg154748 date=1329336522
Anyways, better safe then sorry.
[/quote

Agreed!!
Logged
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.

Offline SwampSinger

  • CJA Members
  • Talks waaay too much!
  • Posts: 6172
  • Baconator
    • mmmmm-bacon
Re: Proper Jack Stand placement under TJ
« Reply #7 on: February 15, 2012, 03:04:53 PM »
Quote from: Bnine on February 15, 2012, 01:08:42 PM
I have dropped vehicles before. Luckily never when I was under one.

You're just quick as a rabit  Bill ... that's all  ;)....

Myself...i'm not so much. I just break bolts.
Logged
Pages: [1]   Go Up
« previous next »