Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: broken body mount bolt  (Read 1081 times)

0 Members and 1 Guest are viewing this topic.

Offline padler

  • Baby Wheeler
  • Posts: 69
broken body mount bolt
« on: April 30, 2006, 08:40:46 PM »
just putting my body lift in and have to get out a few broken bolts. Just wondering what the easiest way to get the broken bolts out is. Was going to try an ez out but not sure if it will bee strong enough, Let me know what you think
Logged

Luxton

  • Guest
broken body mount bolt
« Reply #1 on: April 30, 2006, 08:53:10 PM »
I snapped an ez-out in a heart beat when I was trying to take the stud out of my cross member... I've seen a couple others break as well... don't think I'll trust them to work in much else but plastic at this point.

g'luck
Logged

gsxtacy

  • Guest
broken body mount bolt
« Reply #2 on: May 01, 2006, 12:39:40 AM »
weld a nut onto the head of the bold, then use an impact gun to back it out, works on TORX (R) bolts too, then replace w/ bolts of you're prefrance.
Logged
Pages: [1]   Go Up
« previous next »