Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: U-joints  (Read 841 times)

0 Members and 1 Guest are viewing this topic.

Offline Shearcon79

  • Budget Lift
  • Posts: 274
U-joints
« on: August 21, 2008, 09:08:45 PM »
anyone know where I  can get a 1310/1330 combo U-joint?  I bought my new drive shaft from DSI and didn't realize that the rear yoke in 94/95 YJ's is 1330.
Logged
Green 94 4.0 YJ :
4.5" RE Extreme Duty
33x12.5 MTZ's on 15x8 Black Steelies
Tera-flex Super Short SYE
Drive Products CV Driveshaft
Swing-away Tire Carrier/Bumper/Hitch
Found D44's out of a Waggy...Just need to build them

Offline Rookie

  • CJA Members
  • That CB Yapper
  • Posts: 845
  • build it, break it, rebuild it better
Re: U-joints
« Reply #1 on: August 22, 2008, 06:10:42 AM »
Pats driveline or DSI should have them

Or you could change the yoke to a 1310 yoke then no special parts are required , you can get 131o joints anywhere
Logged
TJ with some stuff

Offline fug

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2345
  • Airdrie Pick n Pull
Re: U-joints
« Reply #2 on: August 22, 2008, 06:17:12 AM »
I Second changing the yoke to make it easier.  I was going to run the combo joint but decided to just change out the yoke so everything was 1310.

I did buy a combo joint at one point tho... think I got it at Napa.  I may still have it around if you are really interested... brand new in the box.
Logged
Fug
TJ Rubicon

Offline BlackYJ

  • Talks waaay too much!
  • Posts: 3392
    • http://www3.telus.net/ccjc/page0002.html
Re: U-joints
« Reply #3 on: August 22, 2008, 07:09:32 AM »
I ran a combo joint in my YJ for a couple years before I got a CV driveshaft.  They can cause vibration and I would definitely recommend changing the yoke to a 1310.  FYI, there are 2 different yokes for the D35 and they are different length
Logged
'95 YJ with a few mods
Pages: [1]   Go Up
« previous next »