Calgary Jeep Association

« previous next »
Pages: 1 [2]   Go Down

Author Topic: uh oh now what?  (Read 2271 times)

0 Members and 5 Guests are viewing this topic.

Offline Pookapotamus

  • Talks waaay too much!
  • Posts: 1123
Re: uh oh now what?
« Reply #15 on: June 24, 2009, 11:52:54 AM »
i think it is only the one layer i will check tonight.
Logged

Offline JENSSEN

  • Talks waaay too much!
  • Posts: 1606
    • Racing For The Cure
Re: uh oh now what?
« Reply #16 on: June 24, 2009, 05:54:43 PM »
Quote from: Pookapotamus on June 24, 2009, 08:40:37 AM
ok so where is the best place to buy sheet metal?


Depending on how much you need I may have some chunks you can have :) or if its still driveable maybe just stop over with it and let me see if I may be able to whip up a quick patch panel PM me
« Last Edit: June 24, 2009, 05:56:37 PM by JENSSEN »
Logged
www.racingforthecure.ca


Definition of Link to this definition of Blasphemy
1. [n] blasphemous behavior; the act of depriving something of its sacred character;

Offline 2grand4u

  • UberWheeler
  • Posts: 480
Re: uh oh now what?
« Reply #17 on: June 24, 2009, 07:03:40 PM »
if it were me i would grind off the rust because i have no way to get to a sand blaster, then i would paint it with some trim clade rust paint, then throw down a chunk of dimond plate with rivits, then bed line it it would look good and all your rust problems are gone.

thats what i would do. at big horn sheet meatal in canmore dimond plate is 2 buck a square foot i get a good deal though work but i'm sure you chould get it cheap some were.
Logged
2011 ford ranger going to get some love soon

Offline Duncan71

  • Budget Lift
  • Posts: 276
Re: uh oh now what?
« Reply #18 on: June 24, 2009, 07:20:48 PM »
I just patched up my floors on my YJ with sheetmetal from princess auto @ 22 bucks for 24" x 48" sheet using bad welds and machine screws.
Logged

Offline extremekustom

  • Stocker
  • Posts: 17
Re: uh oh now what?
« Reply #19 on: June 24, 2009, 09:45:03 PM »
What does it look like now after hitting hit with the wire wheel? From the one picture it looks like the left side by the wheelwell would be very thin after the prep work. Might want to consider cleaning and priming the current floor really well and then just skinning it.
Logged

Offline Pookapotamus

  • Talks waaay too much!
  • Posts: 1123
Re: uh oh now what?
« Reply #20 on: June 25, 2009, 07:17:41 AM »
it does look pretty thin after cleaning and i totaly thought about skinning it but what do i put between the old and the new so that it does not hold water and just rust out the new? i actually think skinning it would be the best because after i bed line it, it will look sweet
Logged
Pages: 1 [2]   Go Up
« previous next »