Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Front Output bearing On Transfer Case  (Read 1631 times)

0 Members and 1 Guest are viewing this topic.

Offline Jrama

  • That CB Yapper
  • Posts: 923
Front Output bearing On Transfer Case
« on: October 26, 2014, 11:50:34 AM »

Anybody have experience replacing this bearing? I have read that it requires opening up the T-Case. I have done a SYE in the past and know whats involved in splitting apart the T-Case. However I don't know how to go about replacing the bearing.


Anybody care to chime in about the intricacies of this job?

Do I have to remove the tail section from the back end of the T-Case or can I just leave it on and split in two?


Thanks !
Logged

Offline Jrama

  • That CB Yapper
  • Posts: 923
Re: Front Output bearing On Transfer Case
« Reply #1 on: October 26, 2014, 04:35:10 PM »
To answer my own questions


1. The Bearing is Held in by a snap ring and is easy to remove once the seal is popped off.

2. You do not need to separate the two, Although getting it back together with RTV and all will be interesting...
Logged

Offline bradley

  • Budget Lift
  • Posts: 121
Re: Front Output bearing On Transfer Case
« Reply #2 on: November 10, 2014, 05:41:01 PM »
Were you able to remove and reinstall that bearing without taking the transfercase out of the jeep?
Logged
2002 jeep tj, 7 inch lift with long arm front and triangulated 4 link rear, 37x12.5x15 maxxis creepy crawler tires, custom front and rear bumpers, 12000 winch, G2 dana 44 front with detroit locker, 44 rear with spool, custom rear skins and flares, sye kit

Offline Jrama

  • That CB Yapper
  • Posts: 923
Re: Front Output bearing On Transfer Case
« Reply #3 on: November 10, 2014, 08:05:58 PM »
Yes
Logged
Pages: [1]   Go Up
« previous next »