Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Gear pattern check  (Read 2130 times)

0 Members and 2 Guests are viewing this topic.

Offline LukeDuke

  • Budget Lift
  • Posts: 159
Gear pattern check
« on: July 22, 2015, 08:55:01 PM »
Doing the set up on my 14 bolt for the Jeepster.   0.006 backlash



How's it look? I think in pretty damn close
Logged
1967 C101 - in 1,000,000 pieces
1973 C104 - in 2,000,000 pieces

RDJP President
http://www.reddeerjeep.com/

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
Re: Gear pattern check
« Reply #1 on: July 23, 2015, 10:06:19 AM »
Need to see the backside. Driveside looks decent.

You can try going a few though either way to see if the contact will broaden out a bit. I suspect if you pull 2-4 thou out it will.

But if the backside looks good, the above pattern is definitely acceptable.
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]

Offline LukeDuke

  • Budget Lift
  • Posts: 159
Gear pattern check
« Reply #2 on: July 23, 2015, 05:16:45 PM »
Here's the coast side. I have the smallest pinion shim in I have at 0.010. Next size it 0.014 and its to much.
Logged
1967 C101 - in 1,000,000 pieces
1973 C104 - in 2,000,000 pieces

RDJP President
http://www.reddeerjeep.com/

Offline LukeDuke

  • Budget Lift
  • Posts: 159
Re: Gear pattern check
« Reply #3 on: July 23, 2015, 05:17:35 PM »
Logged
1967 C101 - in 1,000,000 pieces
1973 C104 - in 2,000,000 pieces

RDJP President
http://www.reddeerjeep.com/

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
Re: Gear pattern check
« Reply #4 on: July 27, 2015, 12:40:43 PM »
If you've already tried the 14 and it goes bad than it looks like you are there.
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]
Pages: [1]   Go Up
« previous next »