Calgary Jeep Association

Author Topic: Anyone need anything?  (Read 693 times)

0 Members and 1 Guest are viewing this topic.

Offline WhiteOut

  • Talks waaay too much!
  • Posts: 1885
Anyone need anything?
« on: June 29, 2008, 01:47:28 AM »
Might hit PnP today for a few things.  Anyone want me to keep an eye open for anything specific?  Heading out around 1:00 ish.

Offline frenchy

  • Talks waaay too much!
  • Posts: 1417
Gear shifter
« Reply #1 on: June 29, 2008, 08:25:27 AM »
Ford NP435 Transmission shifter

Found in Ford trucks, 66-92
Identification
This transmission is 10.8" long and features an aluminum top cover that is retained by eight bolts. The NP435 case is of cast iron.

The Ford NP435 has a 1-1/16" diameter, ten spline input shaft that has a stick-out of 6-1/2" from the front face of the transmission. The pilot tip of the transmission measures .668". The front bearing retainer flange measures 4.850" and the bearing retainer tube is 1.430" in diameter. The front bolt pattern is the symmetrical Ford "butterfly" pattern; roughly 8-1/2" wide by 6-5/16" tall. The input shaft stick-out length is 6-1/2".


Jeep
With stuff

Offline i_go_commando

  • UberWheeler
  • Posts: 350
Re: Anyone need anything?
« Reply #2 on: June 29, 2008, 10:20:49 AM »
electric power steering pump from a toyota mx6? will pay for your trouble. a twisted ankle does not make for good PNP ing. Its on a second generation up till about 96 i belive.

keith

1973 jeep commando -amc 360, 727,203/208, waggy d 44 and amc20- soa, OBA- on hiatus
1958 fc 170 cabover quad cab 3/4 pickup.continetal engine/ 700r4/ dana 300 current project