Calgary Jeep Association

Author Topic: harmonic balencer issue  (Read 701 times)

0 Members and 3 Guests are viewing this topic.

Offline bigdogtroy

  • Stocker
  • Posts: 8
harmonic balencer issue
« on: February 16, 2013, 11:15:14 PM »
so today i noticed i had some noise from the motor i inspect it thought it was my fan clutch because the way it moved so started it up it was not as noisy but now sounded like rubbing found its my harmonic balance its rubbing against my timing cover.it is a v grove pulley so where can i get another one besides the auto wrecker ?.when i get under the jeep (oh and this is a 1990 yj 4.2) it seems the harmonic is separate from the front pulley i can move the balance back and forth a little with a screw driver any help thank you

Offline WagoneerXJ

  • Talks waaay too much!
  • Posts: 1363
  • Bagon Wagon!
Re: harmonic balencer issue
« Reply #1 on: February 17, 2013, 12:13:12 AM »
Doesn't sound good. Most auto parts stores should be able to get you one
98 XJ Sport 2 Dr, 3", 33's and Bushwacker Flat Flares
87 XJ Wagoneer 5", Dana 44, 34" Swamper TSL's
97 TJ 5.2 Magnum V8 swap, 4" and 33" MTZ's- GF's Jeep
84 Mustang GT-Built 351W 5spd
97 XJ - 3.5", 31" BFG. 370,000 KMS and counting!

Offline JENSSEN

  • Talks waaay too much!
  • Posts: 1606
    • Racing For The Cure
Re: harmonic balencer issue
« Reply #2 on: February 17, 2013, 10:26:04 AM »
Sounds like the rubber isolator has given up the ghost ,.. I would not run it until you replace it
www.racingforthecure.ca


Definition of Link to this definition of Blasphemy
1. [n] blasphemous behavior; the act of depriving something of its sacred character;