Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Lunchbox Lockers  (Read 1099 times)

0 Members and 1 Guest are viewing this topic.

SuicidalPenguin

  • Guest
Lunchbox Lockers
« on: August 27, 2006, 02:56:36 PM »
I'm in the middle of putting in a Lock Right locker, but i can't get the shaft that holds the spider gears out.  I popped the cover to find no bolt, but the shaft will not budge, tried just pushing on it, tried a punch and hammer.  Is there something i left out to getting the shaft out? I can stick stuff into the bolt hole and it goes all the way through, so i don't think the PO broke the bolt and it's still in there.

Oh yeah, it's the D35 c-clip diff
Logged

Mac13

  • Guest
Lunchbox Lockers
« Reply #1 on: August 27, 2006, 05:06:23 PM »
I just put an aussie locker in my 35 and there was a small bolt holding the pinion shaft in.  I removed it and the shaft came right out
Logged

Offline bae146

  • UberWheeler
  • Posts: 403
bolt
« Reply #2 on: August 27, 2006, 05:14:53 PM »
I believe it is 10 mm 12 point right?
Logged

HBZ

  • Guest
Lunchbox Lockers
« Reply #3 on: August 31, 2006, 05:50:29 PM »
You may have to use a punch and drive a roll pin out of the case to remove the shaft if you do not have a bolt.

Good luck.

 :D  :D
Logged
Pages: [1]   Go Up
« previous next »