Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: XJ front driveshaft Ujoint issues  (Read 736 times)

0 Members and 3 Guests are viewing this topic.

Offline keener

  • Budget Lift
  • Posts: 254
XJ front driveshaft Ujoint issues
« on: February 13, 2009, 10:40:02 PM »
Hi,
I just got my front driveshaft rebuilt at DSI.  Now the new u-joint won't set  properly in the yoke, because the bearing cups are about 1.5 mm too far apart. They told me to squeeze them together in a vise, which I did, but it didn't help.
Any thoughts on what to do now ?
Logged
'04 Unlimited with a few mods. SOLD
98 XJ with a few mods. SOLD
02 Sahara with lots of Mods.

Offline esi

  • That CB Yapper
  • Posts: 633
Re: XJ front driveshaft Ujoint issues
« Reply #1 on: February 13, 2009, 11:45:30 PM »
make sure none of the pins fell down the grase can sometimes hide them
Logged
Formerly of Boots & Boost Inc
Back farming and fabricating again.

Offline SwampSinger

  • CJA Members
  • Talks waaay too much!
  • Posts: 6172
  • Baconator
    • mmmmm-bacon
Re: XJ front driveshaft Ujoint issues
« Reply #2 on: February 14, 2009, 09:46:34 AM »
I was going to say the same.. a niddle bearing dropped in the cap.
Logged
Pages: [1]   Go Up
« previous next »