think we're on a similar playing field here. my main point is if you don't follow this : (taken from handbook)
This may require adjusting your
speed so that, when you reach the end of the acceleration
lane, you have a gap in the traffic, which will permit you to
enter the flow of traffic safely.
my point is, if we're at the end of that lane, I assume its your job to either speed up into the gap in front of me, or slow down to teh gap behind me. its not my job to 'create' a gap for you by slowing or speeding up. IF i stay constant speed tho, either choice allows you to merge successfully. if i were to slow down to let you in, and you slow down, then we all lose. (as we see on the Canyon meadows/mcleod turnoff)
if you are timing gaps at the end of the merge zone then this sure isn't a problem!!!
but if you are just cruisin' top down havin a blast, and don't bother to 'blend' into a gap, nor shoulder check, and you drive into the side of my jeep, i believe you will get hit for unsafe lane change. cause to my knowledge when u merge into my lane, I should still have that right of way.
but just like the book says, if we all drove like that, we wouldn't have to worry bout it.
just took this off the alberta traffic sight
Entering onto highway
50 A person who is about to drive a vehicle onto an intersecting highway from another highway that is marked by a “merge” sign need not stop the vehicle before driving the vehicle onto the intersecting highway but shall take all necessary precautions and merge the vehicle safely with the traffic on the intersecting highway.
Allow merging
51 A person driving a vehicle on a highway where the highway is marked by a “merging traffic” sign near the intersection of another highway marked by a “merge” sign shall take all reasonable precautions to allow a merging vehicle to enter in safety onto the highway on which the merging is to take place.