Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: jk tie rod ends  (Read 622 times)

0 Members and 1 Guest are viewing this topic.

Offline JK2008blckblck

  • Baby Wheeler
  • Posts: 54
jk tie rod ends
« on: June 14, 2009, 11:06:37 PM »
as i knew would happen eventually, my 37's have screwed the stock tie rod bushings ::), now when i hit a bump wrong im gettin the shakes bad until i stop and go again. anybody know of a good place to get some tougher stuff? need them asap.

thanks.
Logged
2008 jk 2 door
4 inch rough country
37x13.30 ss m-16
procomp rockcrawlers
rcx dual steering stabilizer
1 1/4" rcx body lift
rcx sway bar disco's
bushwacker flares
river raider snorkel
smittybilt front bumer and xrc 8000 winch
PIAA's all over

Offline sn4cktime

  • UberWheeler
  • Posts: 321
Re: jk tie rod ends
« Reply #1 on: June 17, 2009, 02:51:10 PM »
I don't know about putting them on the stock tie rod (might have to ream them out or something) but Rock Krawler used to use MOOG ends on their tie rods.  I think they just use a beefed up Mopar part now instead.

If you can use a moog end, I think NAPA back home used to carry them, maybe they do here.
Logged
----1988 AMC Eagle, mostly a flat XJ at this point----
Pages: [1]   Go Up
« previous next »