Calgary Jeep Association

Author Topic: Removing Soft Top Skin  (Read 1062 times)

0 Members and 1 Guest are viewing this topic.

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Removing Soft Top Skin
« on: July 18, 2011, 03:52:44 PM »
I dropped by soft top off to get a new zipper put on the side window and the shop said they were unable to get the skin/shell off the skeleton/brackets. I was going to head over there in the a.m and was wondering if there is a special way to take the skin off and what tools I would need to do so?  Oh, and it is a factory Soft Top.

Much appreciated
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.

Offline BlackAura

  • Budget Lift
  • Posts: 245
  • 2003 TJ Rubicon (Stock)
Re: Removing Soft Top Skin
« Reply #1 on: July 18, 2011, 03:54:27 PM »
I seem to recall a bunch of screws (phillips maybe?) along the header, and then some velcro holding it to the bars.

I'll check later tonight if no one else posts up!
BlackAura (Kevin)
Migrated to Seattle for a while.

Offline Dagoose

  • Budget Lift
  • Posts: 147
Re: Removing Soft Top Skin
« Reply #2 on: July 18, 2011, 04:19:20 PM »
I seem to recall a bunch of screws (phillips maybe?) along the header, and then some velcro holding it to the bars.

Yup, that's all it is. Also, there are a couple of snaps. I just replaced the skin of my soft top. Takes all of 10 minutes to do.

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Re: Removing Soft Top Skin
« Reply #3 on: July 18, 2011, 04:24:08 PM »
So the screws on there should be phillips head?
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.

Offline Dagoose

  • Budget Lift
  • Posts: 147
Re: Removing Soft Top Skin
« Reply #4 on: July 18, 2011, 04:40:05 PM »
Yup.

Offline FirstTimer

  • That CB Yapper
  • Posts: 717
  • Gettin there!
Re: Removing Soft Top Skin
« Reply #5 on: July 18, 2011, 04:57:15 PM »
Hmm you think the shop could have figured that one out... Oh well fingers crossed it doesn't ran!

Thanks Guys
02' Black TJ Apex on 33s, 2.5"  OME HD lift, Currie JJ CA on all four corners, 4:10 axles, Husky-Liner Rear Swing-Away Bumper and Bushwackers Flat Flares.