Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: JK Rubicon Dana 44 front shafts  (Read 1348 times)

0 Members and 1 Guest are viewing this topic.

Offline w squared

  • Talks waaay too much!
  • Posts: 3400
  • Keamy Hungry!
JK Rubicon Dana 44 front shafts
« on: September 18, 2017, 06:19:04 PM »
I'm looking for a pair of factory take-offs. They don't have to be factory - but most folks who own cromoly shafts tend to have them IN their axles, right?

Specifically the complete left and right front axle shifts (inner, outer, u-joint) from a JK Rubicon. I'm going to send my current shafts to RCV for a rebuild because they deserve a treat after six years of lovin', and I'd like to have something other than rags stuffed into my front axle while that's happening.

I'm even okay with someone who just wants to loan 'em to me....because there's no way that could possibly go bad, right?
Logged
Quote from: TL-Iguana on December 08, 2011, 09:55:33 PM
I followed a rainbow out to a garage and found a leprichaun. The rainbow ended in a potted cactus on his porch, but there was no gold :(

Offline Vinman

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2237
Re: JK Rubicon Dana 44 front shafts
« Reply #1 on: September 18, 2017, 07:20:02 PM »
I have a set I could loan you
Logged
/l ,[____],
 l---L -OlllllllO-
 ()_)-()_)-o-)_)

Quote from: Bnine link=topic=25904.msg162940#msg162940      date=1341881306
. 
 Resident prick is my job and it took me ten years to earn that title

Offline w squared

  • Talks waaay too much!
  • Posts: 3400
  • Keamy Hungry!
Re: JK Rubicon Dana 44 front shafts
« Reply #2 on: September 19, 2017, 03:34:28 PM »
That would be amazing! Thank you Vince!


I am in Moab until Friday, and probably back in Alberta three days after that - why don't I gt in touch once I am back in town?
Logged
Quote from: TL-Iguana on December 08, 2011, 09:55:33 PM
I followed a rainbow out to a garage and found a leprichaun. The rainbow ended in a potted cactus on his porch, but there was no gold :(

Offline Vinman

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2237
Re: JK Rubicon Dana 44 front shafts
« Reply #3 on: September 19, 2017, 04:01:58 PM »
Quote from: w squared on September 19, 2017, 03:34:28 PM
That would be amazing! Thank you Vince!


I am in Moab until Friday, and probably back in Alberta three days after that - why don't I gt in touch once I am back in town?

Sure thing, enjoy Moab
Logged
/l ,[____],
 l---L -OlllllllO-
 ()_)-()_)-o-)_)

Quote from: Bnine link=topic=25904.msg162940#msg162940      date=1341881306
. 
 Resident prick is my job and it took me ten years to earn that title
Pages: [1]   Go Up
« previous next »