Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Proportioning Valve  (Read 831 times)

0 Members and 1 Guest are viewing this topic.

Offline Hi Lo Silver

  • That CB Yapper
  • Posts: 604
    • http://www.fourwheelstampeders.ca
Proportioning Valve
« on: April 20, 2008, 11:43:58 AM »
For those that have done the  disc brake conversion for the rear, did you find it necessary to add an adjustable proportioning valve to the brake system or was the braking ample all the way around?

I'm just starting to install all my old lines on the project but figured I'd hold off till I find  out for sure.

Gunther
Logged

Offline cuzican

  • That CB Yapper
  • Posts: 525
Re: Proportioning Valve
« Reply #1 on: April 20, 2008, 01:00:43 PM »
When I installed my 8.8 I removed the seal on the shaft in the proportioning valve. Works fine now.
Logged
Southern Alberta Coulee Kruzer (new name same great wheelers)
97 TJ with improvements,  05 TJ Unlimited, 06 TJ Rubicon

Offline hps4evr

  • Administrator
  • Talks waaay too much!
  • Posts: 2959
Re: Proportioning Valve
« Reply #2 on: April 20, 2008, 01:57:10 PM »
whan i was at national i did a disc brake conversion on a tj. all the instructions said to do was remove a seal and spring from the fron of the prop valve. the kit came from ssbc. email them for the instructions.
Logged
YJ=Y’all Jealous

Offline BrokenAxle

  • That CB Yapper
  • Posts: 740
    • Broken Axle home page
Re: Proportioning Valve
« Reply #3 on: April 20, 2008, 02:47:18 PM »
i've done a few 8.8 swaps, in xjs and yjs and never had to touch the proportioning valve.  brakes worked great!
Logged

Offline Hi Lo Silver

  • That CB Yapper
  • Posts: 604
    • http://www.fourwheelstampeders.ca
Re: Proportioning Valve
« Reply #4 on: April 20, 2008, 03:18:12 PM »
Mine is the AMC20 in an '84 CJ7 but I think I might just try it first. Just didn't want to loss the oportunity to plumb it all easier when I'm at this stage.
Logged

Offline BlackYJ

  • Talks waaay too much!
  • Posts: 3392
    • http://www3.telus.net/ccjc/page0002.html
Re: Proportioning Valve
« Reply #5 on: April 21, 2008, 07:18:24 AM »
I did not touch my braking system with my 8.8 was installed.
Logged
'95 YJ with a few mods
Pages: [1]   Go Up
« previous next »