Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Tie rod reamer??  (Read 1298 times)

0 Members and 1 Guest are viewing this topic.

Offline 4PLAYZJ

  • UberWheeler
  • Posts: 423
Tie rod reamer??
« on: May 15, 2008, 04:29:40 PM »
What reamer should I buy to ream tie rod holes the same as a stock dana 30??  The only ones I can find ar 5/8" or 11/16"(5/8" = .625 & 11/16" = .688) The Large end of the opening on the stock knuckle is .645.  Is there a special reamer needed or can I just use the 11/16 one and not ream it fully open?
Logged

Offline Gearhead

  • Talks waaay too much!
  • Posts: 1161
Re: Tie rod reamer??
« Reply #1 on: May 15, 2008, 08:37:37 PM »
Snap on  #   R121
Logged

Offline 4PLAYZJ

  • UberWheeler
  • Posts: 423
Re: Tie rod reamer??
« Reply #2 on: May 15, 2008, 09:09:36 PM »
I didnt know if a universal one would work.  Thanks.
Logged

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
Re: Tie rod reamer??
« Reply #3 on: May 16, 2008, 10:11:02 AM »
Northen metallic beside Evo stocks them for Clayton. Either talk to Clay or Northern for a good price on one.
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]
Pages: [1]   Go Up
« previous next »